This is most common with the Original Silhouette. This problem is a large data stream is being sent to the Silhouette machine.The image intricacy (overall line length and number of points or nodes in the job).The presence of content outside of the cutting area, which is also being processed (even though it is not being cut). This has nothing to do with the processing speed or ability of your computer, but rather the Silhouette machine itself. The power light flashing indicates that the Silhouette is on standby and will resume cutting after a few moments. To resolve the concern, remove any additional content that may appear outside of the cutting area and try to cut the job again. Alternately, a brand new document can be started and any content that appears in the cutting area can be copied from the original document and copied into the new document. Make sure to only copy and paste the content that is actually placed inside the cutting area. If this does not resolve the concern and the Original Silhouette model is in use, slow down the cutting Speed setting to 3 (or lower). Slowing the speed will resolve the issue by sending a slower data stream. The Silhouette should no longer stop in the middle of the job. This only needs to be performed for jobs where your Silhouette appears to stop and goes on standby (the power light flashes) in the middle of the job. If the opening of the blade is obstructed with built up materials and your cuts do not fully cut through, it is time to clean your blade.ĭuring the cutting process, some materials that are fibrous in nature (such as paper and cardstock) may collect fiber strands or pulp as the blade cuts through them. Grip the tip of the blade and unscrew it. Gently clean out any debris that has built up by blowing. When you are finished, screw the tip back into place. You should never cut with the tip removed. If using the Passes feature found in the Send panel and the secondary cutting pass is not aligned with the initial cut, the material you are cutting is somehow slipping. You should use the Passes feature when you are using a thicker material type.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |